I have a Raspberry Pi 3 that is not booting with the latest Ardusub-Raspbian Image (downloaded from http://ardusub.com/raspi-setup/ ). The Pi boots successfully with just Raspbian, but with the Ardusub software, the ACT light just goes on but does not flicker. Any ideas?

Please try downloading, extracting, and writing the image to the sd card again. It is possible for the image to get corrupted during these steps. I will try myself in the meantime to verify that the image online is working. -Jacob

I just updated the link on that page to point to the latest ArduSub-Raspbian image.

I have confirmed that the image linked above works. If it still doesn’t work for you after going through the imaging process again, I would begin to think that your RPi 3 may have broken. You could perhaps try installing the official Raspbian image to verify what the issue is. I have had an RPi work…

@jorywong - What size SD card are you using? Please note that the current image requires an SD card of 8GB or greater. If you try to flash it to a smaller SD card it will be corrupt.

@jwalser thanks so much, it’s working now!

Hi Jacob, The link for ArduSub-Raspbian image is not working. Please could you update the link for working image. Regards.

Hi, The link was updated in Jacob’s post : )

Thank you, but it still not work, i think the problem is that image is not adapted for RPi b+ model

Hi Ezzeddine, You can check my answer here: [image] QGroundControl and Raspberry Pi through SSH QGroundControl Hi Ezzeddine, You can check the status of the raspberry pi b+ development here: Right now we don’t have plans to create a working image with it, but you shou…

Booting problem with Raspberry Pi 3

Blue Robotics Software

patrickelectric (Patrick José Pereira) February 14, 2019, 11:33am 10

Hi Ezzeddine,

You can check my answer here:

Topic		Replies	Views
Problem with the ardusub-raspbian.img.gz ArduSub	8	2393	November 9, 2016
Raspbery pi wont boot from Ardusub. fails wiith recover4..elf message ArduSub	2	1405	July 21, 2021
Ardusub Rasbian Image not working ArduSub	4	1948	January 21, 2022
Use Raspberry pi 3 B+ in BlueRov General Discussion ardusub	3	2175	August 31, 2018
Raspberry Pi 3 Model B+ Blue Robotics Software	9	2434	August 6, 2020

Community

BR Website

Software Docs

Autopilot Docs

BR and Beyond

Software

Booting problem with Raspberry Pi 3

Community

BR Website

Software Docs

Autopilot Docs

BR and Beyond

Software

Booting problem with Raspberry Pi 3

Related topics