Hi. I need help to fix this problem: “DETECTED 0 RADIO CHANNELS” I am using CUBE Arduplane, Hereling radio + QGroundControl app. ALL systems are update. ALL cables are connected and checked. THANKS !!! Matias

[E65901F6-0766-442E-82B7-DCDA86E588A7_1_105_c] Please check parameter RC_PROTOCOLS it MUST BE ENABLE (I selected ALL in the menu) NOW IT WORKS !!!

Does the here link show a connection to the RX? or does the RX show a link to the TX? not used that radio before. If it does show a link between them the next thing to check is if your using inverted sbus or non inverted uart control. Plus other radio like spektrum or PPM might plug in differently…

So I did some looking it seems that is a very nice radio it has DUAL sbus through a single cable that splits out, might double check that the sbus1 is plugged in and not sbus2.

Hi Fred, thanks so much for your support. I have checked all above twice and the error message appears I will update Herelink TX/R again tomorrow Best regards Matias

[6D39769A-007D-49C0-B254-3D3CDE741661_1_105_c] All system, Herelink TX/receiver, CUBE etc are updated. All automatic modes, RTL, loiter, and telemetry is working OK Joystick calibration is OK, but when in QGControl or Mission Planner, channel 3 disappears

[965C1372-7CAE-4CBB-9429-6D889E9443C2_1_105_c] Problem is the same here

[DBD94DC9-6122-45F1-90BE-459DBA3C0F1D_1_105_c] this is the joystick calibration (ok) before the RADIO calibration in QGC Herelink

Error message: "detected 0 radio channels" . I can not fix this problem when QGControl RADIO calibration

Blue Robotics Software QGroundControl

matiasduranjorda (matias duran jorda) May 12, 2023, 10:25am 7

this is the joystick calibration (ok) before the RADIO calibration in QGC Herelink

Topic		Replies	Views
Radio Control on Navigator using SBUS Flight Controllers navigator	25	2712	June 3, 2024
Unsual radio spikes Flight Controllers navigator	0	33	July 22, 2024
Radio Control setup - twitching channels BlueBoat	4	128	October 29, 2025
Herelink sbus output not work QGroundControl	2	768	August 27, 2023
Radio Calibration ArduSub	64	7020	December 23, 2016

Community

BR Website

Software Docs

Autopilot Docs

BR and Beyond

Software

Error message: "detected 0 radio channels" . I can not fix this problem when QGControl RADIO calibration

Community

BR Website

Software Docs

Autopilot Docs

BR and Beyond

Software

Error message: "detected 0 radio channels" . I can not fix this problem when QGControl RADIO calibration

Related topics