Holybro PM08 Power module with Navigator

Blue Robotics Products Flight Controllers
1

Hello everyone,

I am considering using the Holybro Power Sense PM08 for our new ROV. However, according to their website documentation, the applicable products are only Pixhawk 4/5X/6C etc, with no mention of Navigator. I am curious if Navigator power port is similar to the Pixhawk 4 power port.

Thanks

2

Hi Ryan -
Looking at the documentation, the pinout matches that of the Navigator:

image
image790×454 30 KB

You should only need to set the appropriate voltage divider and amps per volt parameters in the Autopilot to receive accurate measurements.

3

Hello @tony-white ,

Ok, will do! I’ll set the appropriate parameter based on their doc and update you with the result