How to wire Fathom X pair for 140VDC power and communication

[EliotBR (Eliot)]

Hi @StrikeLines,

@StrikeLines

How do you wire the Fathom X boards to either end of the 140VDC cable? Are all of the necessary components built in to the Fathom X boards, or is some kind of external isolation circuitry required?

From some previous posts:

@rjehangir

The terminals of the Fathom-X tether input are isolated from everything else so if you apply DC power, such as 12V, that power will not be used on the board at all. The signals are capacitively coupled to the wires and won’t be affected by a DC voltage. To use that voltage for something useful, you will have to tap into it separately.

@jwalser

It is designed to handle [up to] 400V [DC], and some customers have had success with this. We do not support this type of use though.

@StrikeLines

Is it really as simple as connecting the two homeplug wires directly to either end of the the tow cable, as shown in this diagram?

(12V power supply wiring for FathomX omitted.)

I haven’t personally used the Fathom-Xs like this, but electrically speaking a DC power supply tries to maintain a constant voltage, and a power-using device generally likes to receive a constant voltage, so you may want a low pass filter of some sort on each end to isolate the DC components, so that the power supply doesn’t try to cancel out the HomePlug signals from the Fathom-X, and so that the device doesn’t receive a noisy power supply.

As Rusty mentioned, the Fathom-X boards will do their own rejection of the DC component to separate out the signal for their internal use, so you only need to worry about rejection of the high frequency signal component acting as noise for your DC devices (although you’ll also need to make sure that any filtering you add has minimal impact on the signal side of the filter).