Hi, I’m sending the command master.mav.manual_control_send(master.target_system, 0, 0, 0, 500, 0) I expect to see only yaw, but the vehicle is also trying to dive. Note, I am in manual control mode Thanks!

Manual_control_send unexpected behavior

jwalser (Jacob) March 22, 2018, 4:57pm 2

Due to some legacy workaround stuff, z is 0-1000 instead of -1000-1000.

1 Like

[Autonomous BlueROV2] MavLink/Ardusub help

Topic		Replies	Views
BlueROV2 Heavy gripper causes down thrust Blue Robotics Software pymavlink	3	894	July 3, 2020
Sending Manual Messages to ROV2 General Discussion	9	3452	February 20, 2022
Manual control not working in depth hold mode ArduSub pymavlink	8	1176	June 12, 2023
Unable to set manual mode via set_mode_manual() Blue Robotics Software	3	1277	July 22, 2017
Manually controlling ROV from pymavlink Blue Robotics Software	2	1459	September 11, 2018