Home        Store        Docs        Blog

Build


MATE ROV AUVSI RoboSub DIY USVs DIY ROVs Kayaks, SUPs, Surf
About the Build category [Build] (1)
NodeROV - NodeJS / HTML based control software [Build] (14)
Low light USB camera cable shielding [Build] (4)
My tether spool ( 2 3 ) [Build] (40)
Build a loader vehicle with custom frame of the ardusub [Build] (3)
t200 diving thruster sea scooter [Build] (4)
Gripper setup - servo issues [Build] (7)
Surface Controller ( 2 3 4 5 6 7 8 9 10 ) [Build] (195)
Possible causes for ESC burning down [Build] (3)
If powering the pixhawk through BEC, can you use BECs with different amp ratings? [Build] (2)
Is it safe to power the pixhawk using a BEC connected to the servo rail without the zener diode? [Build] (3)
SolarSurfer Continuation Project ( 2 3 4 ) [DIY USVs] (72)
ArduSub for ROV‘s without natural longitudinal stability [DIY ROVs] (4)
Building your own 14.8V 18000mAh battery [Build] (13)
Starting construction of ROV [Build] (3)
Tether, base station, and related upgrades ( 2 ) [Build] (31)
Low budget Winch [Build] (3)
Two usb cameras [Build] (5)
Motorize a foil board? [Build] (19)
Dual Rangefinders [Build] (11)
Bluerobotics Thrusters with Ardurover [Build] (8)
Motorized Stand Up Paddle : your advises [Kayaks, SUPs, Surf] (2)
30 bar sensor depth [Build] (2)
3D Printed USV hull files available on Hackaday [DIY USVs] (15)
Building the world's first consumer deep-sea dropcam [Build] (8)
Wich switch is useable? [Build] (11)
PelagicView Rov 2.0 [DIY ROVs] (8)
Network modification [Build] (12)
Perception Pescador Pro 120 with T200 thrusters [Kayaks, SUPs, Surf] (4)
2x 80 w led light [Build] (8)