Hi Im Christian ..Pro ROV pilot and Diver.. 100 questions.. anyone up for it?;)

[paul-unterweiser (undersearobotics.com)]

Hi Christian, welcome aboard. You’re in good compnay, there are a few other veteran ROV pilots here. The short answer to your question is, yes, you can build the BlueROV2 to do just about anything you might think of for an ROV this size. Check out some of Etienne’s threads:

Blue ROV to the next level

OK, I have been using the BR2 professionally for quite some time now and performed inspection of a sunken boat in harsh ocean conditions and I have inspected more that 7000 meters of pipeline from -1 to - 60 meters in open water conditions, drill rig anchor lines in fjord conditions, fish farm anchor lines, 7000 m^2 seabed survey, internal pipe inspection through a 225m long inlet pipe, inspection inside a hydra plant tunnel and more to it. I would say that the little worrier BR2 really stands…

Surface Controller

Hello, We are presently building a surface controller to allow for a more industrial approach to controlling the BlueROV2. (And hopefully smoother) Here are the specs: USB Joystick interface (Naively supported by Windows) 8 axis 4096bit input (4 used, 4 spares) 32 dimmable backlit buttons Hall effect 3 axis joystick Hall effect single axis joystick Tether connector DC jack for power (Fathom board and backlight) External DC 12 V power supply Fathom-X tether board Panel mount Ethernet This is…

Low Cost HD-Zoom-Tilt Project

Hello All, As part of a survey requirement, I have to build an HD zoom camera with tilt capabilities. I wanted a cheap setup that would interface easily with BR2 using as many components readily available from BR’s website. This is what I have done so far and I must admit I am getting pretty happy with the results. First, I purchased an IP HD camera: Low Light H.265/H.264 Sony Sensor IMX291 Hi3516CV300 2MP 1080P Audio IP Camera Module with 2MP 2.7 13.5mm Motorized Zoom Lens|Surveillance Came…